Measure depth from the floor (drying floor, if any) to where the grain meets the wall.

Top of the grain
Peak height

Corn (shelled): about 23° (NDSU AE-84). Peak = 7.6 ft above the wall line.

Hopper, packing and test weight

Grain settles under its own weight, so a bin holds more than its volume suggests: often a few percent in farm bins, more for deep bins, oats and barley. Leave 0 for a volume estimate.

Converts volume bushels to 56-lb standard bushels.

Bushel volume

Grain in the bin

21,617 bushels

peaked
Cylinder (24.0 ft)19,543 bu
Peak (7.6 ft cone)+2,074 bu
Total (volume bushels)21,617 bu
Standard bushels at 56.0 lb test weight21,617 bu
Weight605.3 tons · 549.1 t
Each foot of depth holds814 bu
Equivalent level depth26.55 ft

Bushels = 0.7854 × diameter² × depth × bushels per cubic foot; a cone holds a third of a cylinder with the same base and height. Aeration ducts, unload augers and sweep equipment aren't subtracted.

The formula

level bushels = 0.628 × diameter² × grain depth peak bushels = 0.209 × diameter² × peak height

0.628 is π ÷ 4 × 0.8 bushels per cubic foot; a cone holds one third of the cylinder under it. University of Nebraska's example: a 30-foot bin with 17 feet of grain holds 0.628 × 900 × 17 = 9,608 bushels, and a 6-foot peak adds 0.209 × 900 × 6 = 1,128 bushels, for 10,736 in all. Iowa State's shortcut is the same: average depth = depth at the wall plus a third of the peak height.

Peak height from the filling angle

A full peak rises at the grain's filling angle (angle of repose): peak height = radius × tan(angle). NDSU lists corn (shelled) 23°, soybeans 25°, wheat 25°, barley 28°, oats 28°. Wet grain and fines pile steeper; a spreader levels it.

Level capacity per foot of depth

DiameterBushels per footExample depthLevel bushels
18 ft20416 ft3,257
21 ft27718 ft4,988
24 ft36220 ft7,238
27 ft45821 ft9,619
30 ft56524 ft13,572
36 ft81424 ft19,543
42 ft1,10827 ft29,926
48 ft1,44830 ft43,429
60 ft2,26232 ft72,382
72 ft3,25736 ft117,259
0.8 bu/ft³, level fill, no packing. Example depths are typical, not specific models.

Packing and test weight

Grain compacts under its own weight, so a full bin holds more weight than its volume times the test weight. Research on corn in farm and commercial bins found pack factors from a few percent to more in deep bins (Bhadra et al., 2015). For crop insurance or warehouse inventories, use the method your agency specifies. To turn volume into standard bushels, multiply by test weight and divide by the standard bushel weight; see the test weight calculator.